Loading...
HomeMy WebLinkAbout12. Z-6978-B PC Staff Report 071026ITEM NO.: 12 FILE NO.: Z-6978-B NAME: Equipment Share - Revised Conditional Use Permit LOCATION: 7620 Fluid Drive DEVELOPER: Equipment Share 5710 Bull Run Drive Columbia, MO 65201 OWNER/AUTHORIZED AGENT: Thomas Family Revocable Trust - owner Equipment Share, Inc - agent SURVEYOR/ENGINEER: Thomas Engineering 3810 Lookout Road North Little Rock, AR 72116 AREA: 2.269 acres NUMBER OF LOTS: 2 FT. NEW STREET: 0 LF WARD: 3 CURRENT ZONING: C-3 VARIANCES: None requested. BACKGROUND: On August 14, 2025, the Planning Commission approved a Conditional Use Permit to allow for the development of a tool and equipment rental facility with outside display on the C-3 zoned property at 7620 Fluid Drive. The property includes 6.8 acres. A. PROPOSAL/REQUEST/APPLICANT’S STATEMENT: The applicant is requesting to revise the previously approved conditional use permit. The applicant has acquired 2.269 acres of property located immediately north of the previously approved site. The applicant proposes to incorporate the 2.269 acres into the original CUP for a gravel equipment storage area. B. EXISTING CONDITIONS: The property is currently undeveloped and mostly grass covered. C. NEIGHBORHOOD NOTIFICATIONS: All owners of property located within 300 feet of the site and all neighborhood associations registered with the City of Little Rock were notified of the public hearing. D. ENGINEERING COMMENTS (PLANNING DIVISION): All documents shall be prepared based on the current Arkansas Fire Prevention Codes, City of Little Rock Municipal codes and ordinances, and current Stormwater Management and Drainage Manual.  All streets to meet the current City of Little Rock Master Street Plan.  Any new development shall be reviewed to ensure all codes, specifications, and ordinances are met before issuing any related permits.   ENGINEERING COMMENTS (PUBLIC WORKS): Storm water detention ordinance applies to this property. Maintenance of the detention pond and all private drainage improvements is the responsibility of the developer and/or local property owners’ association and detailed in the bill of assurance.  With site development, provide design of street conforming to the Master Street Plan. construct one-half street improvements (curb and gutter) to Griffin St. including 5-foot sidewalks and access ramps with planned development.  The new back of curb should be located 15.5 ft from the center of the street.  Driveway locations and widths do not meet the traffic access and circulation requirements of Sections 30-43 and 31-210. The width of the property does not allow 2 driveways.  On minor commercial streets, the driveway spacing shall be 200 ft measured from centerline to centerline of driveways.  The width of a driveway must not exceed 26 ft feet.  Driveway locations and widths do not meet the traffic access and circulation requirements of Sections 30-43 and 31-210.  The driveway shown accessing the north gravel lot shall be removed.  This driveway does not meet the spacing requirement of 100 ft from side property lines for minor commercial street and crosses lot 1.  E. UTILITIES/FIRE DEPARTMENT/PARKS/COUNTY PLANNING: Little Rock Water Reclamation Authority: No comments. Entergy: No comments received. Summit Utilities: No comments. AT & T: No comments received. Central Arkansas Water: All Central Arkansas Water requirements in effect at the time of request for water service must be met. The Little Rock Fire Department needs to evaluate this site to determine whether additional public and/or private fire hydrant(s) will be required. If additional fire hydrant(s) are required, they will be installed at the Developer's expense. Please submit plans for water facilities and/or fire protection system to Central Arkansas Water for review. Plan revisions may be required after additional review. Contact Central Arkansas Water regarding procedures for installation of water facilities and/or fire service. Approval of plans by the Arkansas Department of Health Engineering Division and Little Rock Fire Department is required. A Capital Investment Charge based on the size of meter connection(s) will apply to this project in addition to normal charges. This fee will apply to all connections including metered connections off the private fire system. Due to the nature of this facility, installation of an approved reduced pressure zone backflow preventer assembly (RPZ) is required on the domestic water service. This assembly must be installed prior to the first point of use. Central Arkansas Water (CAW) requires that upon installation of the RPZA, successful tests of the assembly must be completed by a Certified Assembly Tester licensed by the State of Arkansas and approved by CAW. The test results must be sent to CAW's Cross Connection Section within ten days of installation and annually thereafter. Contact the Cross Connection Section at 377-1226 if you would like to discuss backflow prevention requirements for this project Fire sprinkler systems which do not contain additives such as antifreeze shall be isolated with a double detector check valve assembly. If additives are used, a reduced pressure zone backflow preventer shall be required. Fire Department: Must Comply with Arkansas Fire Prevention Code 2021 edition All projects submitted for zoning approval must comply with the Arkansas Fire Prevention Code, 2021 Edition, including any comments or requirements provided by the Little Rock Fire Marshal's Office, prior to acceptance. Maintain Access: Fire Hydrants. Maintain fire apparatus access roads at fire hydrant locations as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D103.1 Access road width with a hydrant. Where a fire hydrant is located on a fire apparatus access road, the minimum road width shall be 26 feet, exclusive of shoulders. Grade Maintain fire apparatus access roads as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D103.2 Grade. Fire apparatus access roads shall not exceed 10 percent in grade except as approved by the fire chief. If the grade exceeds 10 percent, approval will be denied and the applicant must submit request to be reviewed by Fire Chief for Approval. Loading Maintain fire apparatus access road design as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D102.1 Access and loading. Facilities, buildings or portions of buildings hereafter constructed shall be accessible to fire department apparatus by way of an approved fire apparatus access road with asphalt, concrete or other approved driving surface capable of supporting the imposed load of fire apparatus weighing at least 75,000 pounds. Commercial and Industrial Developments – 2 means of access. - Maintain fire apparatus access roads as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D104.1 Buildings exceeding three stories or 30 feet in height. Buildings or facilities exceeding 30 feet or three stories in height shall have at least two means of fire apparatus access for each structure. Section D104.2 Building exceeding 62,000 square feet in area. Buildings or facilities having a gross building area of more than 62,000 square feet shall be provided with two separate and approved fire apparatus access roads. Exception: Projects having a gross building area of up to 124,000 square feet that have a single approved fire apparatus access road when all buildings are equipped throughout with approved automatic sprinkler systems. D104.3 Remoteness. Where two fire apparatus access roads are required, they shall be placed a distance apart equal to not less than one half of the length of the maximum overall diagonal dimension of the lot or area to be served, measured in a straight line between accesses. 30’ Tall Buildings - Maintain aerial fire apparatus access roads as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D105.1 – D105.4 D105.1 Where Required. Where the vertical distance between the grade plane and the highest roof surface exceeds 30’, approved aerial fire apparatus access roads shall be provided. For the purposes of this section the highest roof surfaces shall be determined by measurement to the eave of a pitched roof, the intersection of a roof to the exterior wall, or the top of the parapet walls, whichever is greater. D105.2 Width. Aerial fire apparatus access roads shall have a minimum unobstructed with of 26’, exclusive of shoulders, in the immediate vicinity of the building or portion thereof. D105.3 Proximity to building. At least one of the required access routes meeting this condition shall be located within a minimum of 15 feet and a maximum of 30 feet from the building and shall be positioned parallel to one entire side of the building. The side of the building on which the aerial fire apparatus access road is positioned shall be approved by the fire code official. D105.4 Obstructions. Overhead utility and power lines shall not be located over the aerial fire apparatus access road or between the aerial fire apparatus road and the building. Other obstructions shall be permitted to be placed with the approval of the fire code official. Dead Ends.   Maintain fire apparatus access roads at dead end locations as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D103.4 Dead Ends. Dead-end fire apparatus access roads in excess of 150 feet shall be provided with width and turnaround provisions in accordance with Table D103.4. Requirements for Dead-end fire apparatus access roads.  Gates  Maintain fire apparatus access road gates as per Appendix D of the 2021 Arkansas Fire Prevention Code Vol. 1 Section D103.5 Fire apparatus access road gates. Gates securing the fire apparatus access roads shall comply with all of the following criteria:  Minimum gate width shall be 20 feet.  Gates shall be of swinging or sliding type.  Construction of gates shall be of material that allow manual operation by one person.  Gate components shall be maintained in an operable condition at all times and replaces or repaired when defective.  Electric gates shall be equipped with a means of opening the gate by fire department personnel for emergency access. Emergency opening devices shall be approved by the fire code official.  Manual opening gates shall not be locked with a padlock or chain and padlock unless they are capable of being opened by means of forcible entry tools or when a key box containing the keys to the lock is installed at the gate location.  Locking device specifications shall be submitted for approval by the fire code official  Electric gate operators, where provided, shall be listed in accordance with UL 325.  Gates, intended for automatic operation, shall be designed, constructed and installed to comply with requirements of ASTM F 2200.  Parks and Recreation: No comments received. F. BUILDING CODES/LANDSCAPE: Building Codes: No comments. Landscape: Any new site development must comply with the City’s minimal landscape and buffer ordinance requirements. Refer to the Code of Ordinances, Chapter 15 Landscaping and Tree Protection, and Chapter 36, Article IX – Buffers and Screening.  Site development plans, with landscape and screening, must be submitted for review, and approval, prior to site clearing and tree removal.  G. TRANSPORTATION/PLANNING: Rock Region Metro: No comments received. Planning Division: Land Use Plan: The request is in Planning District 12, the 65th Street West Planning District. The development principles of the district include retaining and encouraging residential uses in the area. The Land Use Plan shows Residential Low Density (RL) for the application area. The Residential Low Density (RL) category provides for single family homes at densities not to exceed 6 dwelling units per acre. Such residential development is typically characterized by conventional single family homes but may also include patio or garden homes and cluster homes, provided that the density remains less than 6 units per acre.   To the north and west of the application area are areas designated for Residential Low Density (RL) uses and are characterized by single-family residences and a funeral home. East and south of the application area are areas designated for Commercial (C) uses and are characterized by a mechanic shop, a used car dealership, and a gas station convenience store.   This site is not located in an Overlay District.  Master Street Plan: Mabelvale Pike is a Collector on the Master Street Plan. Collectors are designed to connect traffic from Local Streets to Arterials or to activity centers, with the secondary function of providing access to adjoining property. The standard Right of way is 60’. Sidewalks are required on one side of Collectors. This street may require dedication of right-of-way and may require street improvements.  Bicycle Plan: Mabelvale Pike is on the Master Bike Plan as a Proposed Class III Bike Route. Class III Bike Routes require no additional right-of-way, but either a sign or pavement marking to identify and direct the route.  Historic Preservation Plan: The application, as shown, should have no effect on identified historic resources.  H. Analysis: On August 14, 2025, the Planning Commission approved a Conditional Use Permit to allow for the development of a tool and equipment rental facility with outside display on the C-3 zoned property at 7620 Fluid Drive. The property includes 6.8 acres. The applicant is requesting to revise the previously approved conditional use permit. The applicant has acquired 2.269 acres of property located immediately north of the previously approved site. The applicant proposes to incorporate the 2.269 acres into the original CUP for a gravel equipment storage area. The property is currently undeveloped and mostly grass covered. The additional equipment storage area is accessed via a driveway from the previously approved site and a driveway from Griffin Road along the north property line. The driveways must be adjusted to comply with city code, as per paragraph D. of the staff report. The existing driveway form Fluid Drive at the southeast corner of the additional property must be removed. The perimeter of the gravel equipment storage area must be landscaped as per Chapter 15 of the Code. The proposed site plan for the additional area shows a six (6) foot high chain-link perimeter fence with mechanical gates at the entry drives. All fencing must comply with Section 36-516 of the code. The applicant is not proposing any signage at this time. Any signs placed on the property and the building must conform to Section 36-555 of the City's Zoning Ordinance (signs permitted in Commercial Zones). The site plan does not show a dumpster at this time. Any dumpster placed on the site must be screened and comply with Section 36-523 (d) of the City's Zoning Ordinance. Staff is supportive of the requested conditional use permit. Staff views the request as reasonable. Staff feels the development of the site is appropriate. The proposed commercial use will be compatible with the surrounding mixture of uses in the general area. Staff feels that the proposed use will have no adverse impact on the surrounding area. I. STAFF RECOMMENDATION:  Staff recommends approval of the requested revised CUP, subject to compliance with the comments and conditions outlined in paragraphs D, E and F, and the staff analysis of the agenda staff report. PLANNING COMMISSION ACTION: ( July 9th, 2026 ) The application was placed on the Consent Agenda for deferral to the August 13th. 2026 agenda. There was a motion to approve the Consent Agenda. The motion passed by a vote of 9 ayes, 1 nays and 1 absent. The application was deferred.