HomeMy WebLinkAboutSubdiv Ord7128/22, 12:15 PM Little Rock, AR Code of Ordinances
Sec. 31-117. - General requirements. S
(a) Submission for certification of final plat approval shall consist of the document and two (2)
transparent originals (one (1) shall be a Mylar), the number of prints as established by the
planning staff, the certificates specified in section 31-118 executed and the original bill of
assurance.
An acceptable storage device with the data in CAD compatible .DXF and/or .DWG format containing the
state plane coordinates for all property boundary corners of plat (each phase), street centerline data as
shown on the final plat. Storm drainage as -built information including pipe inverts, length of pipe, size of
pipe, type of pipe, and type of inlets shall be provided in a separate .DXF and/or .DWG file and included on
the submitted acceptable storage device.
The final plat shall be clearly and legibly drawn in black ink on suitable tracing material at the same scale
and dimensions used for the approved preliminary plat. Upon approval and execution of the certificate of
final plat approval, the owner's representative will file the plat for record at the circuit clerk's office and
return a certified Mylar to the city within two (2) working days, unless another period of time is mutually
agreed to by the owner's agent and city representative.
(b) The final plat shall indicate the following information:
(1) Name and address of owner of record and subdivider.
(2) Name of subdivision.
(3) Date of the plat, north point and graphic scale.
(4) Names of all streets.
(5) Boundary information of the tract shall be as follows:
a. Boundary lines shall be indicated by a heavy line.
b. Adjusted Arkansas State Plane Coordinates (north zone, NAD-83) shall be shown for all
boundary corners and all corners of record utilized, along with a statement indicating the
ratio error of closure of the field work.
c. Adjusted bearings and distances shall be shown on all boundary lines and ties to all
corners of record utilized. Where boundary lines are curves, sufficient curve data shall be
provided to establish or reestablish the curve. As a minimum, curve data for each curve
shall consist of radius, arc distance, delta angle and chord bearing and distance. Where
boundary lines are common with previously platted properties, record bearings and
distances shall also be shown.
d. Accurate locations and adequate physical descriptions of all monuments shall be shown
indicating size, type of material and construction thereof, and size and type of survey disk
utilized. Where found monuments are replaced with more permanent monuments, such
replacement shall be noted and a description of the type of found monument indicated.
1/5
about:blank
7/28122. 12:15 PM
Little Rock, AR Code of Ordinances
(6) Streets and alleys within and abutting the subdivision, with street names indicated and
showing the source of dedication.
(7) Street centerlines shall be shown with the following information provided:
a. Bearings and distances along all line segments.
b. Angles of intersection.
c. Curve data for all curves indicating the following:
1. Radius.
2. Length of tangents.
3. Delta angle.
4. Chord bearing and distance.
Sufficient geometric data shall be provided along all rights -of -way to produce a closed
polygon figure within the bounds of the tract being platted.
(8) Source of title giving deed record book and page number or instrument number.
(9) Sufficient geometric data shall be provided along all lot lines (bearings and distances and/or
angles) to produce a closed polygon figure for each lot, with chord bearings and distances
and radii of rounded corners.
(10) Building setback lines with dimensions.
(11) Lot and block numbers.
(12) Easement, buffer strips and public service utility right-of-way lines giving dimensions,
locations and purposes.
(13) Sufficient geometric data shall be provided to produce a closed polygon figure along with a
description of any areas to be dedicated or reserved for public use or acquisition with the
purpose indicated thereon; and of any areas to be reserved by deed covenant for common
use of all property owners.
(14) Accurate locations and descriptions of all monuments.
(15) Key map where more than one sheet is required to present the plat, and in all instances final
plats shall have a location map illustrating an area within a radius of one-half mile of the
proposed subdivision at a scale of one (1) inch to two thousand (2,000) feet. The drawing shall
generally locate arterial streets, highways, section lines, railroads, schools, parks and other
significant community facilities, plus, location within a developing plat.
(16) Location of tract by metes and bounds legal description giving acreage to the nearest one -
thousandth of an acre.
(17) Any area or lot which maybe prone to local flooding shall have the lowest allowable finished
floor elevation indicated on the final plat. This elevation shall be compared to the one (1) in
2/5
about:blank
7/28/22. 12:15 PM Little Rock, AR Code of Ordinances
one hundred -year flood elevation shown on the flood insurance study or, if not available, any
other applicable study in which the one (1) in one hundred -year flood elevation is depicted.
The department of planning and development shall review an approved compliance with
chapter 8, article IV.
(18) Storm drainage as -built information including pipe inverts, length of pipe, size of pipe, type of
pipe, and type of inlets.
(c) Copies of all survey calculations and field notes shall be submitted for review when requested.
When errors are suspected, the planning commission may cause a professional surveyor to check
the final plat for correctness. Certification of approval of water supply and sanitary sewage
disposal by the appropriate agency, when not connected to the municipal system, shall be
submitted.
(Code 1961, § 37-19(a)—(c); Ord. No. 15,929, § 1(h—k), 9-4-90; Ord. No. 16,341, § 1(tt), 1-19-93; Ord. No.
16,861, § 1(tt), (vv), 3-21-95; Ord. No. 17,697, § 3d, 3-17-98; Ord. No. 18,031, § 1(k)—(m), 6-1-99; Ord. No.
20,326, § 1(c), 9-21-10; Ord. No. 21,867, § 1, 5-19-20)
Sec. 31-118. - Certificates.
Each final plat submitted to the staff for approval shall carry the following certificates except that plats
which do not require design of physical improvements or construction may omit the certificate of
engineering accuracy.
CERTIFICATE OF OWNER
We, the undersigned, owners of the real estate shown and described herein, do hereby certify that we
have laid off, platted and subdivided, and do hereby lay off, plat and subdivide said real estate in
accordance with this plat.
3/5
about:blank
7128122. 12:15 PM Little Rock, AR Code of Ordinances
CERTIFICATE OF RECORDING
This document, number filed for record , 19_, in Plat Book , Page
(Signed)
(Name) Clerk
CERTIFICATE OF ENGINEERING
ACCURACY
I, hereby certify that this plat correctly represents a plan made by me, and that the
engineering requirements of the Little Rock Subdivision Rules and Regulations have been complied with.
Date of Execution
I
(Signed)
Name,
Registered, Professional
Engineer No.
Arkansas
CERTIFICATE OF SURVEYING ACCURACY
I, ., hereby certify that this plat correctly represents a boundary survey made or verified by
me, all monuments required actually exist and are correctly shown hereon and that all surveying
requirements of the Little Rock Subdivision Rules and Regulations have been complied with.
415
about:blank
Little Rock, AR Code of Ordinances
7/28/22, 12:15 PM
Date of Execution
Name,
Professional Surveyor
No.
Arkansas
CERTIFICATE OF FINAL APPROVAL
Pursuant to the Little Rock Subdivision Rules and Regulations, and all of the conditions of approval
having been completed, this document is hereby accepted. This certificate is hereby executed under the
authority of said rules and regulations.
Date of Execution
(Signed)
L. R. Planning
Commission
(Code 1961, § 37-19(d)(1); Ord. No. 15,461, § 1, 4-19-88; Ord. No. 15,929, § 1(I), 9-4-90; Ord. No. 15,971, § 10),
12-4-90; Ord. No. 20,326, § 1(d), 9-21-10)
Sec. 31-119. - Fees.
Filing fees for final plat shall be as established by ordinance.
(Code 1961, § 37-19(d)(2))
Cross reference— Fees for subdivision applications, § 23-3.
5/5
about:blank